Forum Replies Created
-
AuthorPosts
-
August 12, 2026 at 1:50 am in reply to: Onion browning times in curry recipes: am I missing something? #1572
also some people just want you to stop crying over onions and move on
heat does not care about your feelingsAugust 11, 2026 at 11:16 pm in reply to: Onion browning times in curry recipes: am I missing something? #1569yeah if the onions go in after the aromatics its usually a speedrun version. if they start first then the recipe wants more patience, maybe not actual brown but close enough
August 11, 2026 at 3:51 pm in reply to: Onion browning times in curry recipes: am I missing something? #1562mushrooms are sneaky like that. one minute theyre cooperating and then the pan fills up with…
five people can spawn a whole forum is a game mechanic somebody is 100% going to abuse
August 10, 2026 at 11:44 pm in reply to: Onion browning times in curry recipes: am I missing something? #1546probably the onion clue, yeah. if they say onions plus ginger garlic right away then it’s usually not a full brown situation
August 10, 2026 at 9:55 pm in reply to: Onion browning times in curry recipes: am I missing something? #1544yeah, that wording is probably the whole trick. I think some recipes mean just cook off the raw bite and get a little color, not full on browned onions
August 10, 2026 at 12:26 pm in reply to: Onion browning times in curry recipes: am I missing something? #1536nah you are not missing much. A lot of recipes are just being vague and calling golden onions brown because it sounds faster. If the heat is low enough to keep them from burning then five minutes is nowhere near deep browning. Fragment of truth, then a lie by stopwatch
Not the exact revision, but I had a closely related setup with the same general failure mode. The thing that saved time was separating the 1Zpresso J-Ultra / puck-prep side from the machine side instead of adjusting both together. Similar experience, not proof for your unit.
The useful documented check is the revision-specific maintenance/service sequence, not a generic espresso-machine video. For Sage Dual Boiler BES920 2024, verify the manual procedure and part number before opening or ordering anything. If the documented test does not reproduce the fault, stop treating that subsystem as proven.
Inference only: because the symptom is repeatable and your listed tests already rule out some obvious causes, I would suspect the narrowest remaining mechanical/setup path before a board-level failure. I would not buy a part from that inference alone.
Right, and I’d add one thing. I’d split only when the side discussion becomes useful enough to deserve being found later.
still no clue what the fish did but honestly i respect the mystery
wait this was the first thread?? lol. congrats, place survived long enough for me to find it
-
AuthorPosts